Back to Thai

How to Make a Coconut Fish Curry

How to Make a Coconut Fish Curry
Curry Recipes Team 15 February 2026

Coconut milk and fish are a natural pairing across Thailand, Malaysia, Sri Lanka and southern India, and the fat protects delicate flesh in a way a thin broth does not. The only real difficulty is keeping the pieces intact.

Which fish holds together?

  • Monkfish - dense and almost impossible to break up.
  • Cod or haddock loin - the thick end rather than the tail, in large pieces.
  • Sea bass and bream - good and more delicate.
  • Salmon - holds well and its richness sits comfortably with coconut.
  • Pollock or coley - inexpensive and entirely adequate.

Thin flaky fish such as plaice or sole falls apart within two minutes regardless of how carefully you treat it.

Why build the sauce first?

Because fish needs five or six minutes and a sauce needs twenty, and there is no way to reconcile those in one pan. Everything should be finished and tasted before the fish arrives, since there is no opportunity to adjust afterwards.

Coconut fish curry

Serves four. Fifteen minutes of preparation and twenty-five minutes of cooking.

Ingredients

  • 700g firm white fish, in 4cm chunks
  • Two 400ml tins of full-fat coconut milk, unshaken
  • 4 tbsp red or yellow curry paste
  • 2.5 tbsp fish sauce and 1.5 tbsp palm sugar
  • 6 kaffir lime leaves, torn
  • 1 stalk lemongrass, bruised and halved
  • 200g cherry tomatoes, halved
  • 150g green beans, halved
  • 2 red chillies, sliced, and a handful of Thai basil
  • Juice of one lime

Method

  1. Pat the fish dry, season lightly with salt and refrigerate until needed.
  2. Spoon the thick cream from the unshaken tins into a wide pan, reserving the thin liquid.
  3. Heat the cream over a medium heat for 5 minutes until it splits and clear oil separates at the edges.
  4. Add the curry paste and fry hard for 3 to 4 minutes, stirring constantly, until darkened and aromatic.
  5. Add the reserved coconut liquid, fish sauce, palm sugar, lime leaves and lemongrass, and simmer gently for 8 minutes.
  6. Add the green beans and cook for 4 minutes, then the cherry tomatoes for 2.
  7. Taste and adjust the seasoning completely now.
  8. Lower the heat so the surface barely moves. Lay the fish in a single layer and do not stir.
  9. Cook for 5 to 6 minutes, spooning sauce over the top, until the fish is opaque and flakes when pressed.
  10. Take off the heat, add the lime juice, basil and chilli, and serve straight from the pan.

Why does the fish go in at a bare simmer?

A rolling boil agitates the pieces until they break apart, and fish proteins tighten and squeeze out moisture at high heat. It also risks splitting the coconut emulsion at the very point when you want the sauce smooth.

Can you use frozen fish?

Yes, and much frozen white fish is excellent. Thaw it fully in the fridge and pat it very dry, since ice crystals rupture the flesh and thawed fish releases a great deal of water that would otherwise thin the sauce.

Which paste suits fish best?

Yellow or red, both of which are gentle enough not to overwhelm it. Green curry paste works and its sharpness competes more. Panang is too thick and sweet for delicate fish. Whichever you use, pull the quantity back slightly from what a chicken curry would take.

Should you use fish stock?

In place of some of the thin coconut liquid, and it deepens the sauce noticeably. Keep it modest at around 100ml for four, since too much pushes the dish toward a soup. If you buy whole fish, simmering the frame for twenty minutes gives you something far better than shop-bought.

How do you know when it is done?

The flesh turns from translucent to opaque and flakes when pressed gently with the back of a spoon. Lift one piece out and check the centre rather than guessing from the surface. Fish carries on cooking in the residual heat of a hot sauce, so pull it a shade early.