Every Malaysian curry begins by frying the rempah in oil until the oil separates out and pools around it. The Malay phrase describes the oil breaking, and it is the single most important technique in the cuisine.
What is actually happening?
The paste is mostly water, from the shallots, garlic and fresh aromatics. Frying drives that water off. Once it has gone, the solids are cooking in oil rather than steaming in their own moisture, and that is when the flavour develops.
The visible oil separating is the signal that the water has gone.
How long does it take?
Twelve to twenty minutes over a medium heat, depending on how wet the paste is and how wide the pan. Most recipes say five minutes, which is not enough for a rempah of any size.
A large rempah for a rendang can take twenty-five. It is the slow part of the cooking and it cannot be shortened.
How do you tell when it is done?
- Oil pools at the edges - tilt the pan and it should run clear and coloured.
- The paste darkens - noticeably, from bright to deep.
- It thickens and holds together - rather than spreading loosely.
- The smell changes - from sharp and raw to rounded and fragrant.
- It stops steaming - the hissing quietens as the water goes.
What happens if you stop early?
The curry tastes raw and sharp, with the shallot and garlic never having mellowed. No amount of subsequent simmering fixes it, because the water has already been replaced by coconut milk or stock and the paste can no longer fry.
It is the commonest fault in a homemade Malaysian curry and it is entirely avoidable.
How much oil do you need?
Generously, around four tablespoons for a rempah serving six. The paste needs enough fat to move in freely, and a dry pan means it catches and scorches before the water has gone.
That oil stays in the dish and Malaysian curries are richer than Indian ones partly for this reason.
What heat should you use?
Medium, and lower it if the paste begins to catch. High heat scorches the shallots and the chilli before the water has evaporated, which gives bitterness rather than depth.
Stir often, and more frequently as it thickens toward the end.
Is it the same in other cuisines?
The principle appears widely. Indian cooking fries a masala until the oil separates, Thai cooking splits coconut cream and fries the paste in the released oil, and Durban cooking judges a curry by the oil on top. Malaysian cooking is simply more explicit about naming it.
Does the pan matter?
A wide heavy pan is considerably better than a deep narrow one, since evaporation depends on surface area and the water has to go before anything else happens. A wok or a wide casserole halves the time compared to a tall saucepan holding the same paste.
Can you fry a rempah ahead?
Yes, and it is a useful habit. A fried rempah keeps two weeks refrigerated under oil and three months frozen, and it drops straight into a pan ready to build on. Doing the slow part in advance turns a weeknight curry into a twenty-minute dish.
What if it starts to catch?
Lower the heat and add a tablespoon of water, which loosens whatever has stuck and buys time. It also sets the process back slightly, since that water has to evaporate again. Better to stir more often at a lower heat than to rescue it repeatedly.
Does the oil go back into the dish?
All of it, and that is the point. The separated oil is now carrying the fat-soluble aromatics from the chilli, turmeric and lemongrass, and it flavours everything added afterwards. Draining it off would remove much of what you spent twenty minutes developing.
Does it apply to a blender rempah?
Equally, and possibly more so. A blended paste holds more water than a pounded one because of the liquid added to get the blades moving, so it takes longer to fry down. Expect a few extra minutes rather than assuming the machine has saved you time overall.